iHome IHM18 - Manual (Page 2)

Power indicator
MODEL: iHM18
size: 215mm x 170mm
Oct 08,10
NOTE: ADJUST iPod VOLUME
TO AVOID DISTORTION
NOTE: For use with iPad,
landscape position is
recommended for best stability.
Using the iHM18
Maintenance
• Place the unit away from sources of direct sunlight or
excessive heat.
• Protect your furniture when placing your unit on a natural
wood and lacquered finish.
• Clean your unit with a soft cloth moistened only with mild
soap and water. Stronger cleaning agents, such as Benzine,
thinner or similar materials can mar the surface.
Battery Installation Right Side Panel
NOTE: THIS UNIT
DOES NOT CHARGE
iPOD
Audio patch cord
On/Off Switch
• Do not mix with used or other battery types/brands
• Replace all batteries at the same time
• Do not open batteries
• Do not dispose of in fire • Do not heat above 75ºC (167ºF)
• Do not expose contents to water
• Do not charge or recharge
• Do not install backwards
For models that require more than one battery
Thank you for purchasing the iHM18. Designed to work with
your iPad, iPhone, iPod, MP3 player or any audio device, this
system provides high quality portable audio. Please read the
instructions carefully before operating the unit and keep for future
reference.
Installing/Replacing Batteries
1. Slide open and remove the battery compartment door located
on the bottom of the unit.
2. Insert 4 “AA” (LR6) batteries (not included), checking that
the + and – ends of the batteries match the drawing inside
the battery compartment. We recommend the use of alkaline
batteries for longer life.
3. Close the compartment cover.
For Best Performance
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Make sure you dispose of batteries properly (see your local
regulations).
• If sound becomes distorted or weak, change the batteries.
• If unit will not be used for some time (30 days +), remove
batteries to avoid potential damage/leakage from batteries.
Listening to an iPod/MP3 player or other audio device
1. Plug the attached audio patchcord located on the back of
the unit into the headphone or Line-out Jack on your iPad,
iPhone,iPod or other audio device.
2. Switch the On/Off switch located on the right side of the unit
to ON. The Power on indicator will light.
3. Turn on your iPod/MP3 player or other audio device, press
play and set desired volume. Place it on the stand if desired.
4. Remember to turn unit and audio device OFF when not in
use to save batteries.
NOTE: A connected iPhone can create audio interference
noise when communicating with a cell tower. Turn
on Airplane mode to disable phone while playing
music.