Invacare Wheelchair - Manual (Page 19)

19
Seat Upholstery
Washer
Crossbrace
FIGURE 2 - REPLACING SEAT POSITIONING STRAP
Rear Phillips Screw
Seat Positioning
Strap
REPLACING SEAT POSITIONING
STRAP (FIGURE 2)
1. If necessary, remove the seat cushion from the seat
upholstery.
2. Remove the two (2) rear phillips screws and washers
that secure the seat upholstery and seat positioning
strap to the crossbraces.
3. Remove the two (2) halves of the seat positioning
strap from the crossbraces.
4. Position the two (2) new seat positioning strap halves
between the seat upholstery and the crossbraces.
5. Reinstall the rear phillips screws and washers that
secure the seat upholstery and seat positioning strap
to the crossbraces.
NOTE: Washer is positioned on top of seat upholstery.
6. If necessary, reinstall the seat cushion onto the seat
upholstery.
U
P
H
O
L
S
T
E
R
Y
PROCEDURE 5 UPHOLSTERY/POSITIONING STRAP
This Procedure Includes the Following:
Replacing Seat Upholstery
Replacing Seat Positioning Strap
REPLACING SEAT UPHOLSTERY
(FIGURE 1)
1. Remove the eight (8) phillips screws and washers that
secure the existing seat upholstery to the crossbraces.
2. Remove existing seat upholstery from the crossbraces.
3. Line up mounting holes in new seat upholstery with
mounting holes in the crossbraces.
4. Securely tighten with existing phillips screws and wash-
ers.
NOTE: Clean upholstery with warm DAMP cloth and mild
detergent to remove superficial soil.
WARNING
Laundering or moisture will reduce flame re-
tardation of the upholstery.
FIGURE 1 - REPLACING SEAT UPHOLSTERY
Seat Upholstery
Phillips
Screws
P
O
S
I
T
I
O
N
I
N
G
S
T
R
A
P
WARNING
After ANY adjustments, repair or service and BE-
FORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage
may result.
Washers