Indesit DV 620 - Manual (Page 8)

6
GB
Turning on the Appliance
Starting a wash cycle ...
After performing all the operations described in the previous
paragraphs, turn the water tap on completely and press ON-
OFF button "A": you will hear a short beep and indicator
light "B" lights up. Now the appliance is on and ready to be
programmed.
Selecting a wash cycle …
To select the wash cycle, turn knob "D" clockwise until the
reference notch on the knob corresponds with the number
or symbol for the cycle you wish to set (have a look at the
wash cycle table on page 7). For a few seconds, the indicator
light "G" concerning the pre-wash cycle phase begins to
flash, then it stays permanently on without flashing for another
10 seconds approximately. During this time, you can modify
your choice of wash cycle. A short beep will indicate the
start of the wash cycle and indicator light "G" corresponding
to the cycle starting phase will light up.
After a few seconds, you will hear a short beep: the wash
cycle has begun and we do not recommend you change it.
Cycle phase indicator lights
The dishwasher is provided with 4 indicator lights "G" which
come on in sequence as the appliance is performing that
specific phase of the wash cycle.
These phases are:
pre-wash, wash, rinses, drying
Cancelling or modifying a wash cycle in progress…..
You can modify the wash cycle in progress, if it has only just
started. Turn the knob anti-clockwise until it reaches the Reset
position and, after a few seconds, you will hear 4 beeps and
indicator light "G" will turn off. This is to inform you that all
the settings have been cancelled.
You are now free to re-set the correct wash cycle.
If you have left out a dish…
You can interrupt the wash cycle by pressing the ON-OFF
button, insert the dish you had forgotten and press the ON-
OFF button again.
The cycle will start up from where you interrupted it.
There's been a power failure? Have you opened the
dishwasher door?
The wash cycle stops and then restarts when the electricity
comes back on or when you shut the door.
At the end of the wash cycle….
The end of the wash cycle is indicated by two short beeps
and the flashing of the drying phase indicator light.
Turn the knob anti-clockwise to Reset in order to reset all
the settings.
Turn the appliance off to cut off the electricity supply.
Turn off the water tap.
Wait a few minutes before unloading the dishes: they are
very hot! If you wait a little while, they dry better thanks to
the steam.
Empty the lower rack first.
Make sure the wash cycle has ended before removing the
dishes!
Warning:
If opening the door soon after the end of the programme, or
during it, stand away from the Dishwasher, to avoid possible
injury from hot steam.