Invacare XPO100 - Manual (Page 31)

SECTION 6—OPERATING INSTRUCTIONS
Part No 1148112 31 Invacare XPO
2
™
FIGURE 6.8 Connecting/Positioning the Nasal Cannula
Adjusting the Pulse Flow Setting
CAUTION
It is very important to select the prescribed level of oxygen
flow. DO NOT increase or decrease the flow unless a change
has been prescribed by your physician or therapist.
NOTE: For this procedure, refer to FIGURE 6.9 on page 32.
1. Turn On the XPO
2
by pressing and holding the power
On/Off button for approximately one second. Each time
the XPO
2
is turned On, a brief alarm will sound. The XPO
2
pulse flow setting at power‐up will be the same flow
setting selected the last time the unit was turned Off.
2. The XPO
2
has five pulse flow settings. Press the flow
selection (+ or ‐) button until your prescribed flow setting
(1 to 5) is illuminated by a blue indicator light.
Nasal
Cannula
Oxygen
Outlet Port
DETAIL
“A”
DETAIL “B”