Integra DTR-7.2 - Manual (Page 59)

59
Controlling an Integra/Onkyo MD recorder
The connector of the Integra/Onkyo MD recorder must be
connected to the DTR-7.2 (see page 14).
1. Press the MD MODE button.
The MD MODE button lights green.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Integra/Onkyo MD
recorder.
Operation buttons:
ON: Turns on and off the MD player (same as STDBY button on the
remote controller).
: Track down
: Track up
: Play
: Stop
: Fast reverse
: Fast forward
R (Rec): Record
: Pause
: Eject the disc
1 to 9, 0, --/---: Numeric keys
ENTER: Enters the settings
You may also use the following buttons:
VOL : Adjusts the volume at the DTR-7.2
MUTING: Activates the muting function at the DTR-7.2
MD
operation
buttons
Numeric keys
Using remote controller
SAT, CABLE, VCR, and TV MODE buttons
No preset codes are programmed into the SAT, CABLE, VCR, and
TV MODE buttons. You can use these buttons to program the
remote controller signals of other devices.
There are two methods. One method is selecting the name of a
different brand from the table, entering the setting number listed, and
calling up the pre-programming code (see page 61). The other
method is learning the commands from the other brand’s remote
control directly into this remote controller (see page 64).
When in the SAT, CABLE and VCR mode, you may use the
following buttons:
VOL : Adjusts the volume at the DTR-7.2
MUTING: Activates the muting function at the DTR-7.2
HOME THEATER CONTROLLER
RC-461M
MD MODE
ON STDBY
VOL
MUTING
ENTER
HOME THEATER CONTROLLER
RC-461M
VOL
MUTING
TV SAT
CABLE VCR