IBM G41/G50 - Manual (Page 12)

9
How to change display modes
Your operating system manual defines the procedure
you should follow to change the default display
mode.
After selecting the optimum mode you need not perform
this operation again unless you change your computer or
software configuration.
Notes:
1. The computer automatically changes display modes to
accommodate some applications. Generally, you will
not notice this.
2. The image size, position and shape may change when
the display mode changes. This is normal and the
image can be readjusted using the monitor controls
(see
Adjusting the image on page 10).
Legend : I = Interlaced
NI = Non-Interlaced
Addressability Refresh Line Rate Notes
720 x 400 70 Hz NI 31.5 kHz DOS Prompt
640 x 480 60 Hz NI 31.5 kHZ VESA
640 x 480 72 Hz NI 35.5 kHZ VESA
640 x 480 75 Hz NI 37.5 kHZ VESA
640 x 480 85 Hz NI 43.3 kHZ VESA
800 x 600 72 Hz NI 48.1 kHZ VESA
800 x 600 75 Hz NI 46.9 kHZ VESA
800 x 600 85 Hz NI 53.7 kHZ VESA
1024 x 768 43 Hz I 35.5 kHZ Interlaced
1024 x 768 70 Hz NI 56.5 kHZ VESA
1024 x 768 72 Hz NI 58.1 kHZ
Table 1. Factory Set Display Modes.
use.doc Page 9 Sunday, July 16, 1995 3:45 PM