Intel 537EX User Manual
537ex chipset
Advertising
Table of contents
Document Outline
- Introduction 1
- AT Command Summary Tables 2
- Table 5. Data Mode Command Summary
- Table 6. V.44/V.42/V.42 bis MNP Command Summary
- Table 7. Fax Identity Command Summary
- Table 8. Fax Class 1 Command Summary
- Table 9. IS-101 Voice Command Summary
- Table 10. Voice DTEÆDCE Character Pairs
- Table 11. Voice DTE¨DCE Character Pairs
- Table 12. Dial Modifiers
- Table 13. S-Register Summary
- Data Mode AT COMMANDS 3
- 3.1 Using AT Commands to Access the S-Registers [Sn?, Sn=x, ?]
- 3.2 Modem Responses and Command Echo [En, Vn, Xn, Wn, Qn]
- 3.3 Modem Reset and NVRAM Commands [DS=m, Zn, &F, &Vn, &Yn, &Wn, &Zn=x]
- 3.4 Modem Identification Commands [In, +FMI, +FMR, +FMM, +GMI, +GMM, +GMR, +GSN, +FMFR?, +FMDL?, ...
- 3.5 Establishing a Modem Connection [A, D, DS = n, S0]
- 3.6 Online Command Mode [Escape Codes, On]
- 3.7 Hanging Up [Hn, S10, Zn, &D2]
- 3.8 Modem-to-Modem Connection Data Rates
- 3.9 Diagnostic Testing [S18, &Tn]
- 3.10 AT Escape Sequences
- Error Correction and Data Compression 4
- Fax Class 1 AT Commands 5
- IS-101 Voice Mode AT Commands 6
- S-Registers 7
- Caller ID 8
- Parallel Host Interface 16C450/16C550A UART 9
- 9.1 UART Emulation in the Controllerless Modem
- 9.2 UART Register Definitions
- 9.2.1 Scratch Register (SCR)
- 9.2.2 Modem Status Register (MSR)
- 9.2.3 Line Status Register (LSR)
- 9.2.4 Modem Control Register (MCR)
- 9.2.5 Line Control Register (LCR)
- 9.2.6 FIFO Control Register (FCR)
- 9.2.7 Interrupt Identity Register (IIR)
- 9.2.8 Interrupt Enable Register (IER)
- 9.2.9 Transmitter Holding Register (THR)
- 9.2.10 Receiver Buffer Register (RBR)
- 9.2.11 Divisor Latch Registers (DLM and DLL)
- 9.3 16C550A UART FIFO Operation