Infinity SW-12 - Manual (Page 6)

3 SW-12
If your receiver/amplifier does not have subwoofer
outputs for the left and right channels or an LFE
output:
C
ONNECTIONS
If you have a Dolby* Digital or DTS ® receiver/processor
with a low-frequency-effects (LFE) output:
• Set Normal/LFE Switch to LFE.
NOTE: In this case, you do not need to use a Y connector. Simply
connect the LFE output on your receiver/processor to either the left
or right input on the subwoofer.
If your receiver/processor has subwoofer
outputs for the left and right channels:
• Set Normal/LFE Switch to Normal.
NOTE: Some receivers have a single subwoofer output (do not confuse
this with a single LFE output as described below). In that case, it is
recommended that you use a Y connector (not included) to maximize
performance.
RECEIVER/AMPLIFIER
Front Speaker Output
B A S S O P T I M I Z A T I O N S Y S T E M
FREQUENCY
R L
180
0
Normal
0 LFE
POWER
AC 120V ~ 60HZ 500W
OFF
ON
®
LEVEL
OFF
GREEN: ON
RED: STANDBY PHASE
LINE LEVEL IN
HIGH LEVEL IN
HIGH LEVEL OUT Infinity Systems
Northridge, CA USA
+ _
R
L
R
L
50 150
CROSSOVER MIN MAX LEVEL
POWER
ON
WIDTH
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
AVERTISSEMENT:
POUR PRÉVENIR LES RISQUES D'INCENDIE OU DE CHOC ÉLECTRIQUE, ÉVITER D'EXPOSER CET APPAREIL A LA
PLUIE OU A L'HUMIDITÉ.
P/N:352153-001
SW-12
B A S S O P T I M I Z A T I O N S Y S T E M
FREQUENCY
R L
180
0
Normal
LFE
RECEIVER/PROCESSOR
POWER
AC 120V ~ 60HZ 500W
OFF
ON
®
LEVEL
OFF
GREEN: ON
RED: STANDBY PHASE
LINE LEVEL IN
HIGH LEVEL IN
HIGH LEVEL OUT Infinity Systems
Northridge, CA USA
+ _
R
L
R
L
50 150
CROSSOVER MIN MAX LEVEL
POWER
ON
WIDTH
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
AVERTISSEMENT:
POUR PRÉVENIR LES RISQUES D'INCENDIE OU DE CHOC ÉLECTRIQUE, ÉVITER D'EXPOSER CET APPAREIL A LA
PLUIE OU A L'HUMIDITÉ.
P/N:351153-001
SW-12
SUBWOOFER OR
LFE OUTPUT
POWER
AC 120V ~ 60HZ 500W
OFF
ON
®
B A S S O P T I M I Z A T I O N S Y S T E M
FREQUENCY LEVEL
OFF
GREEN: ON
RED: STANDBY PHASE
LINE LEVEL IN
HIGH LEVEL IN
HIGH LEVEL OUT Infinity Systems
Northridge, CA USA
R L
+ _
R
L
R
L
180
0
Normal
LFE
50 150
CROSSOVER MIN MAX LEVEL
POWER
ON
WIDTH
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
AVERTISSEMENT:
POUR PRÉVENIR LES RISQUES D'INCENDIE OU DE CHOC ÉLECTRIQUE, ÉVITER D'EXPOSER CET APPAREIL A LA
PLUIE OU A L'HUMIDITÉ.
P/N:352153-001
SW-12
• Set Normal/LFE Switch to Normal.
LOOSEN TERMINALS
INSERT BARE END;
TIGHTEN TERMINALS
1.
2.
BLACK = –
STRIPE = – NO STRIPE = +
RED = +
SW-12 (120V) OM 1/15/04 4:20 PM Page 6