Insignia 105SX - Manual (Page 7)

TRANSDUCER EXCHANGE
Other transducers are available as replacements for the standard
transducer. You may exchange your new and unassembled transducer for
another type by returning it to the address listed in Customer Support.
Some transducers may have additional costs. Refer to the Accessory cata-
log or call Customer Support for information.
BEGINNING INSTALLATION
Now that you have determined the transducer mounting method, you
can begin installation of the 105SX. The fold out installation guide
included provides detailed step by step instructions for installation of the
control head and transducer. For transom mount transducer installations,
you will need the mounting template in the center of this manual.
In addition to the parts included you need the following for installation
and operation:
• A powered hand drill and various drill bits
• Phillips and flat-head screw drivers
• A ruler or measuring tape
• Pen or pencil
• 12 volt power source (your boat’s battery)
• A 1-amp fuse
• A fuse holder (if you are wiring directly to the boat’s battery)
• Silicone sealant (for sealing drilled holes)
• 2-part, slow-cure epoxy (for inside the hull transducer installations)
INSTALLATION PREPARATION
TRANSDUCER EXCHANGE
5