Insignia NS-DPFC01 - Manual (Page 11)

11
Insignia NS-DPFC01 Clock Radio with LCD Photo Viewer
www.insigniaproducts.com
4 Plug in your radio.
Installing the remote control and remote control bracket
To install the remote control and remote control bracket:
1 Put the remote control bracket onto the bracket holder (at the back of
the clock radio).
2 Push the bracket downward until it clicks into place.
3 Insert the remote control into the bracket.
Removing the remote control and remote control bracket
To remove the remote control and remote control bracket:
1 Remove the remote control as shown below.
Cautions
Follow these precautions when using a battery in this device:
• Use only the size and type of battery specified.
• Make sure that you follow the correct polarity as indicated
in the battery compartment when installing the battery. A
reversed battery may cause damage to the clock radio.
• If your clock radio is not to be used for a long period of
time, remove the battery to prevent damage or injury from
possible battery leakage.
• The battery should not be exposed to excessive heat, such
as sunshine, fire, or the like. Dispose of the used battery as
hazardous waste.
• There is a danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent type.
NS-DPFC01 09-0621_MAN_ENG_V2.fm Page 11 Friday, July 24, 2009 12:14 PM