IFB Appliances 17PG1S - Manual (Page 4)

SPECIFICATIONS
230V~50Hz, 1200W(Microwave)
Power Consumption:
230V 900W(Grill)
Rated microwave power output: 700W
Operation Frequency: 2450MHz
Outside Dimensions: 262mm(H)×452mm(W)×330mm(D)
Oven Cavity Dimensions: 210mm(H)×315mm(W)×279mm(D)
Oven Capacity: 17 Liters
Cooking Uniformity: Turntable System {Φ245mm}
Net Weight: Approx.11.3 kg
*All data subject to change, and verification by the user with data available on the nameplate of the
oven. Complaint of error suffers oblivion.
INSTALLATION
1. Make sure that all the packing materials are
removed from the inside of the door.
2. WARNING: Check the oven for any damage,
such as misaligned or bent door, damaged
door seals and sealing surface, broken or
loose door hinges and latches and dents
inside the cavity or on the door. If there is
any damage, do not operate the oven and
contact qualified service personnel.
3. This microwave oven must be placed on a
flat, stable surface to hold its weight and the
heaviest food likely to be cooked in the oven.
4. Do not place the oven where heat, moisture,
or high humidity are generated, or near
combustible materials.
5. For correct operation, the oven must have
sufficient airflow. Allow 20cm of space above
the oven, 10cm at back and 5cm at both
sides. Do not cover or block any openings on
the appliance. Do not remove feet.
6. Do not operate the oven without glass tray,
roller support, and shaft in their proper
positions.
7. Make sure that the power supply cord is
undamaged and does not run under the
oven or over any hot or sharp surface.
8. The socket must be readily accessible so
that it can be easily unplugged in an
emergency.
9. Do not use the oven outdoors.
RADIO INTERFERENCE
Operation of the microwave oven can cause
interference to your radio, TV, or similar
equipment.
When there is interference, it may be reduced or
eliminated by taking the following measures:
1. Clean door and sealing surface of the oven.
2. Reorient the receiving antenna of radio or
television.
3. Relocate the microwave oven with respect to
the receiver.
4. Move the microwave oven away from the
receiver.
5. Plug the microwave oven into a different
outlet so that microwave oven and receiver
are on different branch circuits.
3