Manual de propietario, Surtidor de agua caliente al instante, Modelo hot1 – InSinkErator Hot1 User Manual

Page 7: Troubleshooting

Advertising
background image

Surtidor de agua caliente al instante

Manual de propietario

Modelo Hot1

Installation, Care & Use

Instalación, Cuidado & Uso

Installation, entretien

et mode d’emploi

If you are still experiencing trouble call the AnswerLine

1-800-558-5700

.

TROUBLESHOOTING

WHAT TO DO

Water and steam spits
forcefully from spout
without turning on the
dispenser faucet.

Water is not hot

• Unit is boiling.

May be normal during initial setup.

• The unit is unplugged.

• The electric outlet is inoperative.

• Depress faucet lever to release some water from

the tank.

• Adjust water temperature using dial on tank front.

Remember that at higher altitudes, water boils
at lower temperatures.

• Make sure the unit is connected to a properly grounded

electric outlet.

• Make sure the circuit breaker fuse is functioning properly.

• Check that the outlet is not switched off.

Water is too hot
or not hot enough

• Thermostat is not adjusted to

your needs.

• Adjust the thermostat slowly, then depress or twist faucet handle

for 20 seconds to bring in fresh water to be heated at the new
setting. Allow 5-7 minutes for water to reach new temperature.

Water is dripping from
the spout/vent
intermittently

• The expansion chamber isn’t draining

properly due to low water pressure.

• The spout is blocked.

• Unplug the unit. If the dripping doesn’t stop after a few

minutes, check the supply valve to ensure that is fully
open and there are no obstructions in the water line
reducing the pressure below 30 psi (i.e., a poorly mounted
saddle valve, a clogged water filter, or a partially opened
shut-off valve).

• Unscrew spout end piece and clean out any debris.

Water is dripping
from the spout/vent
constantly

• Debris in the water line may be

in the faucet valve seat causing a
slow water leak.

• Unscrew spout end piece and clean out any debris.

• Depress lever 7-10 times to flush faucet & lines.

Divided stream

• Debris in the end piece.

• Unscrew spout end piece and clean out any debris.

PROBLEM

POSSIBLE CAUSE

Please read Troubleshooting Guide and/or visit
www.insinkerator.com before calling AnswerLine

12

Advertising