Ikelite Underwater Housing for Canon PowerShot G12 - Manual (Page 19)

19
Diagram C
Pull out to
expose shaft
Housing
Lubricate shaft
Tighten set screw down
against this flat area
when replacing the knob.
Lubricate end of shaft
before reinserting into
gland
Diagram B
Loosen Set Screw
Housing
Gland
Control Shaft
Control Maintenance - continued
Slide the shaft back into the control gland and gently slide it back and
forth a few times without fully removing the shaft from the gland.
Replace the knob noting the flat area on the shaft. The set screw in the
knob should tighten down against the flat area on the control so the
knob does not turn on the shaft.