InStep SB100 - Manual (Page 3)

3
Step 2. Rear Wheel Axle Assembly
Tip stroller so the belly bar is on the ground and
the rear legs are up. Hold the axle with the
brake levers up. Align the wheel brackets with
the legs and push on wheel bracket until they
lock into place on both sides (Picture D). Pull
on wheels to make sure they are locked in
place. In the future, if you need to remove rear
axle, push tab that is located inside the wheel
brackets and pull each side off (Picture E).
Step 3. Front Wheel Assembly
Turn stroller on its side. Slide the front wheel
assembly onto the front fork and push until it
locks in place (Picture F). Pull on wheel to make
sure that it is locked in place. Repeat for other
side. In the future, if you need to remove front
wheels, push tab that is located on bottom of
wheel assembly and pull off (Picture G).
Note: There is a lever on the wheel assembly
that locks the wheels from swiveling when used
as a frame carrier.
Step 4. Canopy Assembly
Turn stroller upright. Place the canopy so the
rounded edge is positioned behind the headrest
and snap it onto the back of headrest. Bend the
canopy and snap both sides onto the belly bar
(Picture H).
Congratulations - assembly is now complete!
E
G
F
H
Rear Brake Lever
Rear
Wheel
Dual Front
Wheel
Swivel Lock
Lever
Front Leg
Front Wheel
Swivel
Lock
Lever
Front
Wheel
Removal
Tab
Tab for Rear
Wheel Removal
Rear
Canopy
Snap
Belly
Bar
Snap
Waist
Strap
Cover
D
Rear Wheel
Axle Assembly
Notch in
Leg Up
Notch
Rear
Legs
Rear
Brake
Levers