Intel SBC-455 - Manual (Page 81)

Chapter 5 Flat Panel/ CRT Controller 73
Windows NT 4.0
1. Install Windows NT4.0 as you normally would for a VGA
display. First click the Start button, go to Settings and click
on Control Panel. Choose the Display icon and click on the
icon. In the Display Properties window, click on the Set-
tings tab. Then click on Change Display Type. In the
Change Display Type window, click on the Change button
under Adapter Type. This will bring up the Select Device
window.
2. Place the Windows Ô NT Display Driver Diskette in drive A.
In the Select Device window, click on Have Disk, Press
<ENTER> and the name of the Chips and Technologies, Inc.
Video Controller driver will appear highlighted in the Mod-
els list box. Select Chips and Tech. 65548 PCI(new) and
Click OK to install the selected driver. Click OK to install
the selected driver.
3. Once the installation is complete, the Change Display Type
window will reappear. Click on Close to close the window.
Then the Display Properties window will reappear. Click on
Apply. Restart the system for new settings to take effect.
Driver Installation