Ingersoll-Rand PD03P-XXX-XXX - Manual (Page 5)

PD03P-XXX-XXX (en) Page 5 of 12
Figure 3
FOR THE
AIR MOTOR SECTION
SEE PAGES 6 & 7
COLOR CODE
DIAPHRAGM BALL
MATERIAL COLOR COLOR
Hytrel Cream Black ( )
Santoprene Tan Tan
Viton Yellow ( ) Yellow ( )
( ) Dot
ASSEMBLY TORQUE REQUIREMENTS
LUBRICATION / SEALANTS
NOTE: DO NOT OVERTIGHTEN FASTENERS.
(6) diaphragm nut, 60 - 70 in. lbs (6.8 - 7.9 Nm).
(29) nut, 50 - 60 in. lbs (5.6 - 6.8 Nm), / alternately and evenly, then re-torque after initial run-in.
Apply pipe sealant to threads.
Apply Loctite 242 to threads.
Apply Lubriplate (94276) to all “O" rings, ”U" cups and mating parts.
Apply anti-seize compound to threads and bolt and nut flange heads which contact pump
case when using stainless steel fasteners.
19
21
22
19
21
22
77
15
29
43
7 1
26
60 (PD03P-XDS-XXX,
PD03P-XKS-XXX,
PD03P-XPS-XXX)
60 (PD03P-XES-XXX,
PD03P-XLS-XXX,
PD03P-XRS-XXX)
29
29
61
26
18
17
Torque Sequence
1
6
4
3
5
2
8 Air Side Santoprene (tan)
(white) PTFE 7
View for PD03P-XXS-XXT (PTFE diaphragm)
configuration only
Chamfer (fluid inlet side)
Radius (ball side)
Stainless steel seat installation
5 27 6
42
21
63
42
21
PARTS LIST / PD03P-XXX-XXX FLUID SECTION