IBM AS/400 - Manual (Page 55)

For more information about configuring the 5494, see these books:
v IBM 5494 Remote Control Unit Planning Guide, GA27-3936
v IBM 5494 Remote Control Unit User’s Guide, GA27-3852
AS/400
Prompt
AS/400
Parameter
5494
AS/400 Value 5494 Value Notes Field Subfield
Connection
type CNN 3 1 *NONSWTPP
*MP 0
*SWTPP 1
3 *MP 0
*NONSWTPP
*SWTPP 1
Duplex Duplex 3 2 *HALF 0
*FULL 1
NRZI data
encoding NRZI 3 4 *YES 0
*NO 1
Local
location
name LCLLOCNAME H1 1 - - Values specified for the AS/400
CRTCTLRWS command and
for the 5494 Remote Control
Unit must match. This will
probably match LCLLOCNAME
in the network attributes. This
value will probably match the
LCLLOCNAME in the network
attributes.
Link type LINKTYPE AA - *SDLC 0,2,3 5494 configuration values must
match the values specified for
the LINKTYPE parameter on
the CRTCTLAPPC command.
For APPC controllers that
specify LINKTYPE(*SDLC), the
value specified in the 5494
configuration must be
compatible with the physical
interface (INTERFACE
parameter) specified on the
CRTLINSDLC command.
Select 0 for communications
using SDLC lines other than
X.21 connections.
Remote
control
point name RMTCPNAME 13 - - - Values specified for the AS/400
CRTCTLAPPC command and
for the 5494 Remote Control
Unit must match.
Remote
network
identifier RMTNETID 11 3 - - Values specified for the AS/400
CRTCTLAPPC and
CRTCTLRWS commands and
for the 5494 Remote Control
Unit must match. This will
probably match LCLNETID in
the network attributes and H1:2.
Chapter 7. Communicating with remote workstation controllers 49