Icom IC-7000 - Manual (Page 25)

2
2
16
INSTALLATION AND CONNECTIONS
■Installation
DSingle body mounting DStand
*CAUTION: Non-supplied screws (longer than 8 mm)
may damage the internal units.
MB-62
(optional)
Supplied with
the MB-62*
Nut
Spring washer
Flat washer
Pull back
then up
DFront panel separation
DFront panel mounting
qWhile pulling the front panel latch towards you,
slide the front panel to the left (fig. 1).
wAttach the optional OPC-1443 to the main body
and tighten the supplied screw as in fig. 2.
eAttach the other end of the OPC-1443 to the de-
tached front panel as in fig. 3.
CAUTION: NEVER detach/attach the front panel
when connecting the DC power supply (or battery).
Be sure to disconnect the DC power cable from the
[13.8 V] socket on the transceiver rear panel.
qAttach the MB-105 to a flat surface using the four
supplied screws (fig. 1).
wFix the detached front panel to the MB-105 as il-
lustrated in fig. 2.
BE CAREFUL to mount the MB-105 so that the
front panel attaches with the correct side up.
Separation cable
(OPC-1443)
Separation cable
(OPC-1443)
To remove
fig. 1 fig. 2 fig. 3
Latch
fig. 1
fig. 2
To raise the stand:
With the transceiver upside down, pull the stand to-
wards the rear panel and then upwards, as illus-
trated below.