Indesit FE 10 K GB - Manual (Page 4)

4
Important: The power supply to the appliance must be
cut off before any adjustments or maintenance work is
done on it.
Unpacking
Remove the outer packing from the oven. Open the door
outwards and remove packing from the shelves. Take out
the plastic envelope containing instruction book, guarantee
card and 4 fixing screws.
Installation of Built-in Ovens
In order to insure that the built-in appliance functions
properly, the cabinet containing it must be appropriate.
The figure below gives the dimensions of the cutout for
installation under the counter or in a cabinet wall unit.
595 mm.
595 mm.
20 mm.
543 mm.
5 mm.
567 mm.
23 mm.
593 mm.
45 mm.
558 mm.
595 mm.
595 mm.
20 mm.
543 mm.
5 mm.
567 mm.
23 mm.
575-585 mm.
558 mm.
595 mm. 45 mm.
min.
45 mm.
min.
In order to ensure adequate ventilation, the back panel of
the cabinet must be removed. Installing the oven so that it
rests on two strips of wood is preferable. In the case where
the oven rests on a continuous, flat surface, there must
be an aperture of at least 45 x 560 mm.
560 mm.
45 mm.
To fasten the oven to the cabinet, open the door of the
oven and fasten it by inserting the 4 wood screws into the
4 holes locate on the perimeter of the frame.
The panels of the adjacent cabinets must be made of
heat resistant material. In particular, cabinets with a veneer
exterior must be assembled with glues able to withstand
temperatures of up to 100 ° C.
Once the appliance has been installed, the electrical parts
must be totally protected from all contact, according to
current safety regulations.
All protecting parts should be firmly fixed and should
require the use of a tool for removal.
When installing below a built-in hob, ensure that there are
air inlets and outlets for ventilating the interior of the cabinet
adequately. Assembly examples are given in figs.
Electrical connection
Ovens with a three-pole power supply cable are designed
to operate with alternated current at the supply frequency
and voltage indicated on the data plate (at the bottom of
the oven dashboard). The earthing conductor of the cable
is the yellow-green conductor.
Two types of connection are provided:
Connection n° 1
Connecting the power supply cable to the mains.
Fit a normalized plug to the cable, which corresponds to
the load indicated on the data plate; if the cooker is
connected directly to the mains, an omnipolar circuit-
Installation