ISEKI CISCO SYSTEMS OL-5450-10 - Manual (Page 36)

Usage Notes
36
Release Notes for VPN Client, Release 4.0 through Release 4.0.5.D
OL-5450-10
The InstallShield Knowledge base article q108020 addresses this problem. To
view this article go to the following URL (CSCea43117):
http://support.installshield.com/kb/view.asp?articleid=q108020
Microsoft has a fix for this issue. For more information and to obtain the fix, go
to the following URL:
http://support.microsoft.com/default.aspx?scid=kb;en-us;329623
VPN Client cTCP Connection Fails If Checkpoint Client Is
Installed
When the Checkpoint VPN-1 Securemote client is installed with the 4.0 VPN
Client, and the VPN Client attempts to connect using cTCP, the 4.0 VPN Client
cannot make the connection. Connections do work with UDP, NAT-T, and
non-NAT connections.
To make a connection with cTCP when the Checkpoint VPN-1 Securemote is
installed, you must disable the Check Point SecuRemote driver in the Connections
Properties. To do this, you must be administrator. Follow these steps:
Step 1 Click Start > Settings > Control Panel >Network and Dial-up Connections.
Step 2 Select the Local Area Connection you use.
Step 3 Click on File > Properties.
Step 4 Uncheck Check Point SecuRemote, and click OK.
(CSCea31192)