Invacare 1363 - Manual (Page 2)

2 HYGIENIC SHOWER CHAIR Part No. 1073902
ASSEMBLING THE BACK (FIGURE 1)
NOTE: If your Hygienic Shower Chair does not have a back, proceed to ASSEMBLING THE LEGS in
this instruction sheet.
NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in this
instruction sheet.
1. Remove all contents from the package.
2. Insert the back support tube into the back as shown in FIGURE 1.
3. Install mounting screw through back and back support tube and securely tighten. Repeat
STEPS 2 - 3 for opposite side.
4. Refer to ASSEMBLING THE LEGS in this instruction sheet.
FIGURE 1 - ASSEMBLING THE BACK
Mounting
Screw
Back
Back Support
Tubes
ASSEMBLING THE LEGS (FIGURES 2 AND 3)
NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in this
instruction sheet.
1. Position top leg over bottom leg aligning cutouts of both legs. Refer to FIGURE 2.
FIGURE 2 - ASSEMBLING THE LEGS - TOP AND BOTTOM LEG POSITION
Cutout
Top
Leg
Bottom
Leg
2. Install mounting screw through flat washer, top leg, bottom leg and lock washer. Secure
with wing nut. Refer to FIGURE 3.
3. Refer to ATTACHING LEGS TO THE SEAT in this instruction sheet.