Infinity PS212W - Manual (Page 5)

5 PS210W, PS212W (120V)
S
YSTEM
C
ONNECTIONS
Choose either Wireless or Wired Connection; then follow the appropriate instructions.
WIRELESS
If your receiver/processor does not contain a Dolby Digital
or DTS processor, but has subwoofer outputs:
Connecting the Subwoofer for Wired Applications
If you have a Dolby ® Digital or DTS ® receiver/processor with
a low-frequency effects (LFE) or subwoofer output:
NOTE: If your receiver/processor has only one sub out, you
may use either the L or R input.
WIRED
Connecting the Subwoofer for Wireless Applications
Step 1.
Connect a subwoofer cable from the subwoofer or LFE output of
your receiver to the Sub In › on the transmitter.
Step 2.
Plug the transmitter module into the wall outlet, and connect the
included power supply and power cord to the transmitter
. Make
sure the Transmitter Antenna ⁄ is extended upward.
Step 3.
Set the ID Code on the transmitter ‹ and subwoofer ¢ to the
same position, as described on page 6. When connected properly,
the LED on the rear of the subwoofer will be orange.
Step 4.
Set the Low-Pass Selector § to the “Off” position.
NOTE: Some receivers have two subwoofer outputs. In that case,
use either connector.
Sub In
ID
CODE
DC18V
1 2 3 4
PS212W.PS210W.OM 9/15/08 2:17 PM Page 5