Image IMSB73920 - Manual (Page 11)

A. The filter can be removed for cleaning or replace-
ment (see CHECKING AND CLEANING THE FIL-
TER on page 13).
B. The underwater light can be used for night opera-
tion (see USING THE CONTROLS on page 12). The
spa includes both red and blue covers for the light.
C. The temperature probe monitors water temperature.
D. The volcano jet provides a soothing foot massage.
E. The whirlpool jet diverts the water flow four different
ways. By turning the outer ring, you can divert the
water flow between the volcano jet (D), the other jets
on the spa, and the whirlpool jet (E), which creates a
whirlpool action. Note: The outer ring may be hard
to turn while the pump is turned on high.
F. The four suction fittings provide water to the
pumps. The suction covers should always be in
place over the fittings. Never operate the spa with-
out the suction covers in place.
G. An optional ozone generator can be purchased and
installed to utilize the ozone jet. Ozone helps sani-
tize the spa with minimal chemical treatment.
H. The console controls the spa jets, turns the under-
water light on and off, and adjusts the water tem-
perature setting (see USING THE CONTROLS on
page 12).
I. The four air controls regulate the air flow to the
whirlpool, hydrotherapy, and volcano jets.
J. The two neck jets can be adjusted to spray sooth-
ing water on your neck.
K. The twenty rotary jets provide a spinning massage.
L. The dual rotary jets provide a pulsating massage
action. Rotate the outer ring counterclockwise to
turn the jets on. Rotate the outer ring clockwise to
turn the jets off.
M. The three variable-flow jets are fully adjustable.
Turn the outer rings to regulate the flow.
N. The power massage jet provides a soothing mas-
sage to your lower back. Turn the outer ring to reg-
ulate the flow.
O. The skimmer cleans the surface of the water.
11
Spa Shell Diagram
A
O
L
B
D
I
E
I
H
F
M M
M
J
J
L
L
L
L
K
K
K
K
K
K
K
G
C
N
L
L