Insignia NS-LCD32-09 - Manual (Page 4)

4
• Press EXIT to close the Manual Channel Set menu.
ƒ Reception can vary by channel depending on the broadcast power level of a given station. Contact
your cable provider.
o If you are using an antenna:
ƒ Try running an autochannel search:
• Press MENU. The on-screen menu opens.
• Press ^ or v to select Setup, then press > to enter Setup menu.
• Press ^ or v to select Tuning Band, then press > to select Air.
• Press
^ or v to select Auto Ch Search, then press > to begin searching for channels. Your TV
memorizes all analog and digital channels you receive.
OR
Try manually adding the channel:
• Press MENU. The on-screen menu opens.
• Press ^ or v to select Setup, then press > to enter Setup menu.
• Press ^ or v to select Manual Channel Set then press > to enter Manual Channel Set menu.
• Press ^ or v to select the channel.
• Press ENTER to toggle between Not Viewable and Viewable.
• Press EXIT to close the Manual Channel Set menu.
ƒ The signal strength of the channel may be low.
• Check the signal strength of the channel (Please note that the signal strength is only displayed
on digital channels):
o Press MENU. The on-screen menu opens.
o Press ^ or v to select Setup, then press > to enter Setup menu.
o Press ^ or v to select DTV Signal, then press > to view Signal Level display.
• If the signal level is Weak:
• Make sure your antenna is connected securely to the TV.
• Move the antenna around the room or close to a window.
• Use a basic indoor set-top antenna designed to pick up both VHF and
UHF.
OR
Use a set-top antenna that has a built-in signal amplifier.
OR
Use an antenna mounted on your roof or in your attic.
• For more information about antennas and the available channels in your area,
visit www.antennaweb.org .
o Press EXIT to close the Signal Level display.
ƒ The UHF band (channels 14 and higher) is more directional than VHF (channels 2-13) and more
sensitive to obstacles (such as trees, tall buildings, and mountains) that lie between your antenna and
the broadcast tower. Getting good UHF reception can be more difficult than VHF.
ƒ If you're getting marginal reception of digital signals, both the picture and sound might freeze or break
up to the point that it's not watchable. If you're really on the fringes—either too far from a tower or with
too many obstacles in the way—you'll see a black screen that says "No signal."
ƒ Reception can vary by channel, depending on the location and broadcast power level of a given station.
I am having issues with the picture on my TV (e.g., stripe on the screen, blue lines/dots, red line, etc.).
• Make sure your cables are connected correctly and securely to the jacks on the TV.
• The cables you are using may be bad, try a new set.
• If you are using an antenna, the signal strength of the channel may be low.
o Check the signal strength of the channel (Please note that the signal strength is only displayed on digital
channels):
ƒ Press MENU. The on-screen menu opens.
ƒ Press ^ or v to select Setup, then press > to enter Setup menu.
ƒ Press ^ or v to select DTV Signal, then press > to view Signal Level display.
• If the signal level is Weak:
o Make sure your antenna is connected securely to the TV.
o Move the antenna around the room or close to a window.