JVC HR-S7960E - Manual (Page 23)

Masterpage:Right-NoTitle0
EN
23
Filename [HRS7960E2-EN.fm]
Page 23 April 22, 2003 3:07 pm
Next Function Memory
The Next Function Memory “tells” the recorder what to do after
rewinding. Before continuing, make sure the recorder is in the
Stop mode.
a- For Automatic Start Of Playback
Press
3
, then press
4
within 2 seconds.
b- For Automatic Power Off
Press
3
, then press
1
within 2 seconds.
c- For Automatic Timer Standby
Press
3
, then press
#
(TIMER) within 2 seconds.
NOTE:
The Automatic Power Off does not work if “AUTO TIMER” is set
to “ON” (
੬
49) and if any timer programming has been made.
If “AUTO TIMER” is set to “ON”, the recorder directly goes into
the Timer-Standby mode at the same time when the
1 is
pressed for the Automatic Power Off.
Repeat Playback
Your recorder can automatically play back the whole tape 100
times repeatedly.
1 Start playback.
Press
4
.
2 Activate Repeat Playback.
Press
4
and hold for over 5 seconds, then release.
● The Play indicator (
$ ) on the front display panel blinks slowly.
● After playing back a tape 100 times, the recorder stops
automatically.
3 Stop Repeat Playback.
Press
8
at any time.
● Pressing
4 , 3 , 5 or 9 also stops Repeat Playback.
NOTE:
Repeat playback is not possible with a cassette recorded in EP
mode.
Manual Tracking
Your recorder is equipped with automatic tracking control.
During playback, you can override this and adjust the tracking
manually by pressing the PR buttons.
1 Override automatic tracking.
During playback, press
p
on the remote control.
2 Adjust the tracking manually.
Press PR + or – on the remote control.
● Press
p again to return to automatic tracking.
NOTE:
When a new tape is inserted, the recorder enters the automatic
tracking mode automatically.
Soundtrack Selection
Your recorder is capable of recording three soundtracks (HI-FI L,
HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing AUDIO changes the soundtrack as follows:
NOTES:
● “HI FI L
j h R” should normally be selected. In this mode,
Hi-Fi stereo tapes are played back in stereo, and the normal
audio track is played back automatically for tapes with only
normal audio.
● For instructions on recording stereo and bilingual
programmes, refer to page 26.
● “O.S.D.” must be set to “ON” or the on-screen displays will
not appear (
੬
pg. 49).
TRACK
USE
On-Screen Display
HI FI
L j h R
For Hi-Fi stereo tapes
HI FI
L j
For main audio of Bilingual tapes
HI FI
h R
For sub audio of Bilingual tapes
NORM For audio-dubbed tapes
HI FI
NORM
For audio-dubbed tapes
HRS7960E-EN.book Page 23 Tuesday, April 22, 2003 3:07 PM