JVC DR-MH300BEK - Manual (Page 34)

H EN 34
Input/Output Setting
A
Access the setup menu.
B
Select “FUNCTION SET UP”.
C
Select “VIDEO IN/OUT”.
D
Set the input/output terminal.
A
Select and confirm on AF-1 INPUTB.
B Select and confirm on AL-1 OUTPUTB.
C
Select and confirm on AL-1 INPUTB.
D Select and confirm on AL-2 SELECTB.
0 See the description below for the combinations
of settings.
E
Exit setup.
Ⅲ Possible combinations
*1 Switching to RGB signals is automatic.
*2 Component videos will be output from the [COMPONENT] terminal. Be sure to set to ACOMPONENTB if viewing via component
video.
*3 With this setting, signals from the [L-2 IN/DECODER] terminal will be output to the [L-1 IN/OUT] terminal even if this unit is
turned off, except during EPG data downloading.
*4 This setting cannot be made if AL-2 SELECTB is set to ASAT VIDEO/RGBB or ADECODERB.
9 The SCART connector supports the
connection of composite video signals.
Settings must correspond with the type of
video signal to use and the device to
connect.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT:
0 For normal use, you can leave the default settings as
they are.
0 See the following page regarding each setting. Setup
Menu AF-1 INPUTB, AL-1 OUTPUTB, AL-1 INPUTB,
AL-2 SELECTB [ P102, 103] h - k
0 For image output format other than A576iB (during up
convert or progressive scan), viewing is not possible
as the images are distorted.
A
,
E
B - D
SELECT
FUNCTION SET UP
VIDEO IN/OUT
SELECT
CONFIRM
F-1 INPUT VIDEO
S-VIDEO
AL-2 SELECTB (*1)
AL-1 OUTPUTB
ASCART VIDEOB ASCART S-VIDEOB ASCART RGBB ACOMPONENTB (*2)
AVIDEO/RGBB 3 3 3 3
AS-VIDEO/RGBB 3 3 3 3
ASAT VIDEO/RGBB 3 3 3 (*3)
ASAT S-VIDEO/RGBB 3 3 (*3)
ADECODERB 3 3 (*3)
AL-1 INPUTB
AVIDEOB
3 3 3 3
AS-VIDEOB 3 (*4) 3 (*4)
DR-MH300SE.book Page 34 Thursday, November 24, 2005 9:12 AM