JVC VN-SE400U - Manual (Page 7)

7
[AUTO SEQUENCE]
ON: Enable the auto sequence function.
OFF: Disable the auto sequence function.
[CAMERA]
Select a camera (from 1 to 8) to display its image.
(No image will be shown if the selected number is not
attached to any camera.)
Click Camera Shift buttons to change the camera
number to the next or previous. (Unattached numbers
to any cameras are skipped.)
[POSITION]
Select one position to make the camera to point to the
registered position. The valid position is from 1 to 99, or
HOME. (No image will be shown if the selected position
number is not registered on the camera.)
Click Position Shift buttons to change the position
number to the next or previous. (Unregistered numbers
to any positions are skipped.)
[PAN/TILT Adjustment buttons]
Arrow buttons are provided to control the pan/tilt posi-
tion of the camera.
The camera position is returned to the home position by
[HOME] button.
[SPEED] (For PAN/TILT Adjustment)
Set the speed of the panning/tilting.
(1 is the slowest setting, and 8 is the fastest setting.)
4. RM-P2580U(A) Controller
RM-P2580U(A) Controller controls the following model.
RM-P2580U(A)
Camera Shift buttons
PAN/TILT Adfustment buttons
Position Shift buttons
[IRIS]
Adjust the camera iris.
CLOSE: Close the iris.
OPEN: Open the iris.
[FOCUS]
Adjust the focusing.
NEAR: Focus on the near subjects.
FAR: Focus on the far subjects.
AUTO FOCUS: Adjust the focusing automatically.
[ZOOM]
Adjust the zoom ratio.
WIDE: Wide angle
TELE: Tele angle
[SPEED] (For ZOOM and FOCUS)
Set the speed of FOCUS and ZOOM.
(1 is the slowest setting, and 3 is the fastest setting.)
< A.SEQ tab >
< A.PAN tab >
[AUTO PAN]
ON: Enable the auto pan function.
OFF: Disable the auto pan function.
[AUTO PTL]
ON: Enable the auto patrol function.
OFF: Disable the auto patrol function.