JVC HR-J278EU - Manual (Page 15)

Filename [HRJ278EU1.fm]
Masterpage:Right
EN
15
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
Activate Index Search.
Press w or e ( 2 or 6 ). “ 2 1” or “ 6 1” is
displayed on the TV screen and search begins in the
corresponding direction.
● To access index codes 2 through 9, press w or e repeatedly
until the correct index number is displayed.
Example:
To locate the beginning of B from the current position, press
w
twice.
To locate the beginning of D from the current position, press
e
once.
● When the specified index code is located, playback begins
automatically.
Skip Search
During playback, press 30 SEC 1 to 4 times to skip over
unwanted sections. To resume normal playback, press
4 .
● Each press initiates a 30-second period of fast-motion
playback. Normal playback resumes automatically.
Next Function Memory
The Next Function Memory “tells” the recorder what to do after
rewinding. Before continuing, make sure the recorder is in the
Stop mode.
a- For Automatic Start Of Playback
Press 3 , then press 4 within 2 seconds.
b- For Automatic Power Off
Press 3 , then press 1 within 2 seconds.
c- For Automatic Timer Standby
Press 3 , then press # (TIMER) within 2 seconds.
Repeat Playback
Your recorder can automatically play back the whole tape 100
times repeatedly.
1 Start playback.
Press 4 .
2 Activate Repeat Playback.
Press 4 and hold for over 5 seconds, then release.
● The Play indicator ( $ ) on the front display panel blinks
slowly.
● After playing back a tape 100 times, the recorder stops
automatically.
3 Stop Repeat Playback.
Press 8 at any time.
● Pressing 4 , 3 , 5 or 9 also stops Repeat Playback.
Current position
Index number
HRJ278EU1.fm Page 15 Thursday, March 15, 2001 1:52 PM