John Deere AC-350 - Manual (Page 15)

Operation
Operator’s Manual 1
OperAtION (CONtINUeD)
STOP SPACE HEATER:
CAUtION: NeVer UNpLUG heAter WhILe
heAter IS rUNNING. heAter MUSt GO
thrOUGh pUrGe CYCLe. the pUrGe CYCLe
COOLS the COMBUStIONChAMBer. DAMAGe
tO heAter CAN OCCUr IF COMBUStION
ChAMBer IS NOt COOLeD. DO NOt reStArt
heAter UNtIL pUrGe CYCLe IS COMpLete.
1. Turn thermostat dial to lowest temperature setting. This will
cause heater flame to go out. The motor will continue to
run during the purge cycle. This allows the fan to cool the
combustion chamber. When the purge cycle is finished, the
motor will stop. Do not unplug heater until purge cycle is
finished.
. Unplug extension cord from outlet.
. To temporarily stop heater, set thermostat at a temperature
lower than air around heater. Heater will cycle back on if air
temperature around heater matches thermostat setting.
TO RESTART SPACE HEATER:
CAUtION: DO NOt reStArt heAter UNtIL
pUrGe CYCLe IS FINISheD. the pUrGe
C Y C L e C O O L S t h e C O M B U S t I O N
ChAMBer.
1. Wait until purge cycle is finished after stopping heater.
. Repeat steps under "Start Space Heater".