JobSite Systems JobSite AB50-X2 - Manual (Page 8)

6
TROUBLESHOOTING
AB50-X2 will not power up
Check to see that the AB50-X2 is plugged into an
unswitched outlet.
Check to see that the POWER/ACTIVE LED is lit.
AB50-X2 will not activate (Current Sense Mode)
Make sure that the TV is plugged into the sensed
outlet on the AB50-X2. May need to adjust sensitivity.
AB50-X2 will not activate (12V Trigger Mode)
Measure the voltage on the TRIGGER IN terminal.
The voltage must be 3-30 VAC/DC to activate the
AB50-X2.
Check the polarity of 3.5mm mini-plug correct.
(Tip=+12VDC; Sleeve=ground. DC only)
AB50-X2
Multizone Receiver
Right/
Left
Right
Speakers
AB50-X2
TV Variable
Line Out
TV-Power
Cord
To Current Sensing Outlet
Left
M-64 MULTI-ZONE RECEIVER
INSTALLATION DIAGRAM