John Lewis JLBIMW01 - Manual (Page 9)

í
9
Building In
1. Remove all packaging and check carefully for any signs of damage.
2. If the microwave is fitted in position C, ensure that the minimum
air gaps are maintained as shown in the diagram.
3. Secure four cupboard retention blocks in position using the setting
template (TMAPTA004URR0).
4. Fit the appliance into the kitchen cupboard, lift over the
bottom/front blocks then push slowly and without force, until the
front frame of the oven seals against the front opening of the
cupboard.
5. Ensure the appliance is stable and not leaning.
6. Fix the oven in position with the screws provided. The fixing
points are located within the louver areas at the top and bottom of
the oven (see diagram, item 1, on page 5).
7. Fit the frame fastener caps to the four fixing positions (2 spare caps
are provided).
8. It is important to ensure that the installation of this product
conforms to the instructions in this operation manual and the
conventional oven or hob manufacturer’s installation instructions.
65 mm 5 mm
460 mm
20 mm
min. 20 mm
450 mm
Conventional
oven
Position A
Position C
min. 20 mm
450 mm
Position B
'
Position A
Position C
Position B
Conventional
oven
The microwave can be fitted in position A, B or C:
Chimney
Cable clip
Chimney
Cable clip
Niche Size
Position
W D H
Chimney
(Min)
Gap
Between
Cupboard &
Ceiling
A 560 550 450 20 50
B 560 550 450 20 50
C 560 550 460 20 Not Applicable
All Measurements in (mm)