Jwin JV-TV2040 - Manual (Page 7)

-7-
P
UTTING IT ALL TOGETHER
You will be pleased with the ease of installation of this unit. With just a few quick
steps, your unit will be up and running in a very short period of time.
1. Connect the camera to the monitor.
Be sure that the power cable is not connected.
a. Connect one end of the 60’ cable
to the camera cable and connect
the other end to the Channel (CH)
port on the back of the monitor as
follows:
ƒ If you are using only 1 camera:
connect the 60’ cable to the
CH1 port on the back of the
monitor.
ƒ If you are using 2 cameras:
connect the first 60’ cable to the
CH1 port on the back of the
monitor and then connect the
second cable to the CH2 port.
2. Connect the power cable:
a. Attach one end to the power connector port
on the left side of the rear of the monitor.
b. Plug the AC/DC adapter into an electrical
outlet.
That’s all there is to set up! You are now ready to start your unit and adjust the
monitor image and sound.