Jensen JCR-260 - Manual (Page 9)

8
This unit features an AUX IN jack for connecting your iPod, MP3 player or other digital
music player.
1. Connect the headphone jack of your external device to the AUX IN jack located on
the back of the JCR-260 (cable not included).
2. Turn the JCR-260 on and it will enter the AUX function mode once an external
device is plugged into the AUX IN jack.
3. Start playing your iPod, MP3 player or other external audio device.
4. Slowly adjust both volume controls on the JCR-260 and the external device.
5. Turn off your iPod, MP3 player etc. when finish listening. Turn the JCR-260 off and
unplug the AUX IN jack.
Remark: Once the AUX IN jack is plugged during POWER ON mode, it will
automatically enter the AUX mode no matter what position the AM/FM Band Selector is
in. Remember to disconnect the cable from JCR-260 after use in order to be able to
listen to the radio again.
ALARM OPERATION
SETTING THE WAKE UP TIME
1. Press and hold the ALARM SET button and then press the FAST button to set the
coarse wake up time.
2. Press and hold the ALARM button and repeatedly press the SLOW button to set the
correct wake up Hour/Minute.
NOTE
1. There is a PM INDICATOR located in the bottom right-hand corner of the clock
display. Be sure to observe the PM indicator when setting the alarm to make sure
the alarm time is set correctly for AM or PM. If the PM indicator is 'On', the alarm
time will be "PM". If not, the alarm time will be "AM".
2. If you plan to set dual alarms, later alarm will not sound if former alarm still
sounding. Therefore, please make sure there is sufficient time internal
between two alarms. For example, more than one hour.
CHECKING THE WAKE UP TIME
Whenever you want to check the wake up time, simply press the ALARM SET button
after select ALARM 1 or 2. The display will change from current time to wake up time.
Release the ALARM SET button to return to current time.
WAKE TO RADIO
1. Slide the FUNCTION SELECTOR to “ON” position, select the band, station, and
adjust the volume to a level that you wish to hear when the wake up time is reached,
then slide the FUNCTION SELECTOR to the “AUTO” position. The selected alarm
indicator will light on the display.
2. Reconfirm the wake up time setting by pressing the ALARM SET button.
3. At the selected wake up time the radio will turn 'On' and will play for about one hour
and then shut off automatically.
4. To stop the radio before it shuts off, press the ALARM OFF button. The radio will
stop but the alarm remains set and will turn the radio on again at the same time on
the following day.