JVC XV-521BK - Manual (Page 19)

Getting started
16
Getting star
ted
XV-521BK [J] EN
LVT0435-001A
To use the remote control unit for TV operation
You can operate your TV from the remote control unit.
Setting the remote control signal for operating your TV.
1 Holding down TV/VIDEO, enter the manufacturer code of your TV listed below by using the numeric buttons (0 - 9).
Do not release TV/VIDEO. Keep holding it until the next step is completed.
2 Press 7 (STOP) while holding down TV/VIDEO.
The following buttons can be used for operating the TV:
3 Try to operate your TV by pressing DVD POWER - TV POWER while holding SHIFT.
If your TV turns on or off, you have successfully set the control signal.
No. Manufacturer
01 JVC
02 MAGNAVOX
03 MITSUBISHI
04 PANASONIC
05 RCA
06 SHARP
07 SONY
08 TOSHIBA
09 ZENITH
Manufacturer code list
• The remote control unit is initially set for operating a JVC TV.
• If there is more than one code listed for the manufacturer of your TV, try them one by one until you succeed.
NOTES
Example:
To enter the manufacturer code “01”:
Press “0” then “1.”
to
SHIFT
9 1
TV 0 TV 100+
TV 9 TV 1
+10 0
TV/VIDEO
TV
VOL
DVD POWER
TV POWER
SHIFT
TV
ch
Turns the TV on or off.
Changes the TV channels.
Adjusts the TV volume.
Selects the TV channels.
*For some TVs, pressing “+10” while holding down SHIFT
functions as the “100+.” “+10” functions as the ENTER button if
your TV requires pressing the ENTER button after selecting a
channel number.
Switches input mode (either TV or VIDEO).
No. Manufacturer
10 HITACHI
11 PANASONIC
12 SAMSUNG
13 SANYO
14 SANYO
15 SAMSUNG
Returns to the previously selected channel (only valid for JVC
TVs).
TV RETURN
10
To control the volume of a JVC’s amplifier or receiver
You can control the volume of a JVC’s amplifier or receiver by using the AMP VOL button on the remote control unit.
AMP
VOL
SHIFT