JVC CA-HXZ9 - Manual (Page 13)

8
English
Connecting Other Equipment
You can connect audio equipment—used only as a playback
device.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all connections
are complete.
Be sure that the plugs of the audio cords are colored: White
plugs and jacks are for left audio signals, and red ones for
right audio signals.
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jacks by using an audio cord (not
supplied).
Audio equipment
To audio output
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to rotate the voltage selector so that the
voltage mark is pointing at the same voltage as where you are
plugging in the unit. (See the back cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection
procedures are complete.
Now, you can plug the AC power cord.
• If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
• When you connect the AC power cord into a wall outlet,
the unit automatically starts the demonstration. To cancel
the demonstration, see “Canceling the Demonstration” on
page 9.
IMPORTANT: Be sure to check all connections to be done
before plugging the AC power cord into a wall outlet.
Voltage mark
To connect surround speakers
By connecting surround speakers to the SURROUND
SPEAKERS jacks, you can enjoy surround effect.
• Connect the right surround speaker to the RIGHT jack.
• Connect the left surround speaker to the LEFT jack.
Ideal speaker layout
To enjoy multichannel sound, locate speakers as follows.
Right
surround
speaker
Left
surround
speaker
Left
main speaker
Right
main speaker
Subwoofer
Left
surround
speaker
Right
surround
speaker
EN01-08.CA-HXZ9[UW]f.p65 03.1.30, 10:59 AM 8