Jabra A320s User Manual
Page 25
The Bluetooth server must be specifically configured to provide Network Access service.
However, after a Bluetooth device is configured as a Network Access server, it cannot act as a
Network Access client without being re-configured.
In the next sections to follow, we will discuss about how to set up Network Access in different
Windows platforms.
Windows 2000, Server-side Setup
1. From the Windows Control Panel, select Network and Dial-up Connections.
2. Right-click
the
Local Area Connection icon and select Properties. The Local Area
Connection Properties dialog box opens.
3. Click
the
Sharing tab. Select Enable Internet Connection Sharing.
4. Click
OK.
5. Click
Yes to enable Internet connection sharing.
Windows XP, Server-side Setup
1. Have your Windows XP compact disc handy. You may need it during the setup
process.
2. From the Windows Control Panel, select Network Connections.
3. Right-click
the
Local Area Connection icon and then select Properties.
The Local Area Connection Properties dialog box opens.
4. Click
the
Advanced tab. Select Enable Internet Connection Sharing to allow
network users to connect, control, or disable this Internet connection.
5. Select
Allow other network users to connect through this computer’s Internet
connection.
6. Click
OK.
Windows 98SE & Windows ME, Server-side Setup
Internet Protocol routing software is required on Windows 98SE and Windows ME servers. A
downloadable trial version of WinRoute Lite is available on the Tiny Software, Inc. Website –
To configure the server:
1. From the Windows Control Panel, double-click the Network icon.
2. Click
the
Configuration tab. Select TCP/IP -> Bluetooth LAN Access Server
Driver (scroll down if necessary).
3. Click
Properties and select the IP Address tab.
4. Select
Specify an IP address.
5. Enter an IP address (suggested value – 192.168.1.1) and a Subnet Mask
(suggested value – 255.255.255.0).
6. Click
OK in both dialog boxes.
7. Click
Yes to restart the computer.
©2005 All rights reserved.
25