Jeep 74383 - Manual (Page 14)

Assembly
• Face the back end of the vehicle.
• Align the holes in the taillight with the holes in the
vehicle body.
• Insert two #8 x 1" screws through the holes in the taillight
and into the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Repeat steps 22 and 23 to assemble the other taillight
lens and taillight housing to the vehicle body.
Taillight
Rear of
Vehicle
Body
• Turn the vehicle on its side.
• Fit a traction band around a wheel.
• Slide a slotted screwdriver under the traction band to
push the traction band onto the ridge in the center of
the wheel.
Hint: If the traction band is difficult to fit around the wheel,
you may want to soak it in warm water to soften it slightly.
• Repeat this procedure to assemble a traction band to
each wheel.
• Turn the vehicle upright.
Traction
Band
Wheel
Ridge
• “Snap” the center of the spark plug wire set onto the
battery clamp (engine cover).
• Fit each of the spark plug wire ends into the holes on
the sides of the battery clamp (engine cover).
IMPORTANT! You must install your Power Wheels ®
battery in your vehicle before assembling the battery
clamp (engine cover) under the hood. Please refer to
“Battery Installation” on page 16 for detailed instructions.
Spark Plug
Wire Set
Spark Plug
Wire End
Hole
Battery Clamp
(Engine Cover)
Bottom View
14
23
24
25
74388pr-0921.qrk 7/13/01 1:38 PM Page 14