Jenn-Air W10300219A - Manual (Page 5)

5
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility.
■ Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
■ Install the dishwasher as specified in these instructions.
■ Have everything you need to properly install dishwasher.
■ Avoid damage from freezing to dishwasher and water lines
leading to dishwasher. Damage from freezing is not covered
by the warranty.
■ This dishwasher is manufactured for indoor use only.
■ Install and level dishwasher on a floor that will hold the weight,
and in an area suitable for its size and use.
Product Dimensions
Installation Clearances
Cutout Dimensions
Preferred Utility Area
NOTE: All holes should be drilled at 1½" (3.8 cm) diameter.
Water Supply Requirements
■ A hot water line with 20 to 120 psi (138 to 862 kPa) water
pressure.
■ 120°F (49°C) water temperature at dishwasher.
■ Flexible stainless steel braided fill line (½" minimum plastic
tubing is not recommended).
23
³⁄₈
"
(59.5 cm)
19
¹⁄₄
"
(48.9 cm)
1
¹⁄₂
"
(3.75 cm)
24"
(61 cm)
33 ³⁄₄ "
(85.7 cm)
A. Left-hand or right-hand water connection route
B. Left-hand or right-hand electric connection and drain route
24"
24"
(61 cm)
33 ⁷⁄₈ "
(86 cm)
(61 cm)
A
B
25"
(63.5 cm)
¹⁄₂ "
(1.3 cm)
8"
(20.3 cm)