John Deere UB12D - Manual (Page 3)

Flashlight Operator's Manual 3
Do not look at the light directly.
Do not open the front cover immediately after using the flashlight because the bulb is
very hot.
Be sure to turn the switch OFF before replacing the bulb or when not using.
Do not expose the flashlight to rain.
Do not shock or disassemble the flashlight.
Do not allow the flashlight to contact gasoline, thinner etc.
Do not leave the flashlight in a car or the like that tends to be exposed to the scorching
heat of the sun (above 60°C). Otherwise, troubles can result.
CAUTION
Operation
OPERATION:
1. BATTERY INSERT/REMOVAL
Correctly insert the battery into the flashlight (Fig. 1)
Pressing on the latch, remove the battery from the flashlight. (Fig. 1)
2. HEAD ANGLE ADJUSTMENT
Adjusting the lighting angle, hold the handle then adjust the head angle.
It can be adjusted at 0°, 30°, 60°, 90° and 110°. (Fig. 2)
3. BULB REPLACEMENT
a.
Remove the front cover. (FIg. 3)
b. Replace the bulb. (Fig. 4) (A spare bulb is set in the head.)
Remove
Insert
Latch
Battery
Push
Handle
Fig. 1 Fig. 2 Fig. 3 Fig. 4
Battery EB9, EB12 series (sold separately)
Bulb 12 V, 0.7 A
Operating time Approx. 3 hours
(Using full charged EB1220BL battery)
Dimensions (without battery) 85 mm (diameter) x 252 mm (length)
Weight (without battery) 0.28 kg
Specifications