JVC UX-V9RMD User Manual

Page 3

Advertising
background image

G-2

Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate
the apparatus as follows:
1 Front:

No obstructions and open spacing.

2 Sides/ Top/ Back:

No obstructions should be placed in the areas shown by the
dimensions below.

3 Bottom:

Place on the level surface. Maintain an adequate air path for venti-
lation by placing on a stand with a height of 10 cm or more.

Vorsicht: Ausreichende Belüftung
Zur Vermeidung von elektrischen Schlägen, Feuer und sonstigen
Schäden sollte das Gerät unter folgenden Bedingungen aufgestellt
werden:
1 Vorderseite:

Hindernisfrei und gut zugänglich.

2 Seiten- und Rückwände:

Hindernisfrei in allen gegebenen Abständen (s. Abbildung).

3 Unterseite:

Die Stellfläche muß absolut eben sein. Sorgen Sie für ausre-
ichende Luftzufuhr durch Aufstellung auf einem Stand mit mindes-
tens 10 cm Höhe.

Attention: Aération correcte
Pour prévenir tout risque de décharge électrique ou d’incendie et
éviter toute détérioration, installez l’appareil de la manière suivante:
1 Avant:

Bien dégagé de tout objet.

2 Côtés/dessus/dessous:

Assurez-vous que rien ne bloque les espaces indiqués sur le
schéma ci-dessous.

3 Dessous:

Posez l’appareil sur une surface plane et horizontale. Veillez à ce
que sa ventilation correcte puisse se faire en le plaçant sur un sup-
port d’au moins dix centimètres de hauteur.

Voorzichtig: Goede ventilatie vereist
Om brand, elektrische schokken en beschadiging te voorkomen, moet
u het toestel als volgt opstellen:
1 Voorkant:

Geen belemmeringen en voldoende ruimte.

2 Zijkanten/boven-/onderkant:

Geen belemmeringen plaatsen in de hieronder aangegeven
zones.

3 Onderkant:

Op vlakke ondergrond plaatsen. Voldoende ventilatieruimte voorz-
ien door het toestel op een onderstel met een hoogte van 10 cm of
meer te plaatsen.

Precaucion: ventilación correcta
Para evitar el riesgo de descargas eléctricas e incendio y prevenir
posibles daños, instale el equipo en un lugar que cumpla los sigu-
ientes requisitos:
1 Parte frontal:

Sin obstrucciones, espacio abierto.

2 Lados/parte superior/parte posterior:

No debe haber ninguna obstrucción en las áreas mostradas por
las dimensiones de la siguiente figura.

3 Parte inferior:

Sitúe el equipo sobre una superficie nivelada. Mantenga un espa-
cio adecuado para permitir el paso del aire y una correcta venti-
lación, situando el equipo sobre un soporte de 10 o más cm de
allura.

Attenzione: Per una corretta ventilazione
Per prevenire il rischio di scosse elettriche e di incendio ed evitare pos-
sibili danni, collocare le apparecchiature nel modo seguente:
1 Parte anteriore:

Nessun ostacolo e spazio libero.

2 Lati/Parte superiore/Retro:

Lasciare libere le zone indicate dalle dimensioni di seguito.

3 Base:

Collocare su una superficie piana. Consentire un’adeguata venti-
lazione dell’impianto appoggiandolo su un tavolinetto alto almeno
10 cm.

15 cm

15 cm

UX-V9RMD

UX-V9RMD

10 cm

15 cm

15 cm

15 cm

1 cm

1 cm

MD

MICRO COMPONENT SYSTEM

UX-V9RMD

TUNER

CD

CD

OPEN / CLOSE

MD

EJECT

PHONES

TAPE / AUX

BAND

STANDBY / ON

DOWN

UP

MULTI CONTROL

Front view
Vorderansicht
Face
Vooraanzicht
Vista frontal
Vista frontale

Side view
Seitenansicht
Côt
Zijaanzicht
Vista lateral
Vista laterale

Advertising