JVC HR-XVS44U - Manual (Page 37)

Masterpage:Right-No-Heading
EN
37
Filename [XVS44U_07S-VHS.fm]
Page 37 25 August 2003 11:07 am
F
Enter the channel position.
Press CH +/–.
G
Set the tape speed.
Press SP/EP.
H
Return to the normal screen.
Press PROG. or OK. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears. If “PROGRAM NOT COMPLETED
PROGRAM OVERLAP” appears on the TV screen, see
page 40.
● Repeat steps B – H for each additional program.
I
Engage the unit’s timer mode.
Press TIMER. The unit turns off automatically and “#”
appears on the front display panel.
● To disengage the timer mode, press TIMER again.
To Timer-Record Weekly Or Daily Serials:
— anytime during steps C through G, press WEEKLY (number
key “9”) for weekly serials or DAILY (number key “8”) for daily
serials (Monday – Friday). Either “WEEKLY” or “DAILY” appears
on the TV screen. Pressing the button again makes the
corresponding indication disappear.
NOTES:
● You can program this unit to timer-record as many as 8
programs. If you try to program the unit to record a ninth,
“PROGRAM FULL” appears on the TV screen. To record the
extra program, you must first cancel any unnecessary
programs. (
੬
pg. 39)
● In case of a power failure after programing, the unit’s memory
backup keeps your selections for approximately 5 seconds.
● Programs that start after midnight must have the next day’s
date.
Cable Box or DBS Receiver Users
To timer-record a satellite broadcast using Express Timer
Programing:
A Perform steps A – I. In step F, enter “F-1” or “L-1” for
the channel position depending on the connector being
used.
B Set the DBS receiver to the appropriate channel before
the selected program begins.
C Leave the DBS receiver’s power on.
XVS44U_01.book Page 37 Monday, August 25, 2003 11:08 AM