JVC RX-6012VSL - Manual (Page 17)

14
English
T SETTING
CONTROL
DOWN UP
DIGITAL 2 terminal setting
DIGITAL 1 terminal setting
Digital Input (DIGITAL IN) Terminal
Setting
When you use the digital input terminals, you have to register what
components are connected to which terminals (DIGITAL IN 1/2).
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until
“DIGITAL IN” appears on the
display.
The display changes to show the current setting.
2. Press CONTROL UP
5/DOWN ∞
to select the appropriate digital
terminal setting.
• Each time you press the button, the display
changes to show the following:
1 DVD 2 CD “ 1 DVD 2 TV “ 1 DVD 2 CDR “
1 CD 2 DVD “ 1 CD 2 TV “ 1 CD 2 CDR “
1 TV 2 DVD “ 1 TV 2 CD “ 1 TV 2 CDR “
1 CDR 2 DVD
“ 1 CDR 2 CD “ 1 CDR 2 TV “
(back to the beginning)
Note:
When shipped from the factory, the DIGITAL IN terminals can be used
as the digital input for the following components.
• DIGITAL 1 (coaxial): For DVD player
• DIGITAL 2 (optical): For CD player
DVD VTR TV SOUND
CD TAPE/CDR
SOURCE NAME
FM/AM
INPUT DIGITAL
L
SPK DIGITAL AUTO
R
“AUTO” appears for about 4 seconds.
Continued to the next page.
Selecting the Analog or Digital Input Mode
When you have connected digital source components using both the
analog connection (see page 5) and the digital connection methods
(see page 7), you need to select the input mode correctly.
On the front panel :
1. Press one of the
source selecting
buttons (DVD, TV
SOUND, CD, or
TAPE/CDR)* for
which you want to change the input mode.
Note:
* Among the sources listed above, you can select the digital input
only for the sources which you have selected the digital input
terminals for. (See “Digital Input (DIGITAL IN) Terminal Setting.”)
2. Press INPUT DIGITAL to select
the digital input mode (AUTO).
The DIGITAL AUTO indicator lights up on
the display, and the digital signal indicator
for the detected signals also light up.*
• When “AUTO” is selected, the receiver automatically detects
the incoming signal format.
* The followings are the analog/digital signal indicators on the
display to indicate what type of the signal comes into the
receiver.
DIGITAL AUTO : Lights up when “AUTO” is selected as
the digital input mode.
ANALOG : Lights up when the analog input is
selected.
LINEAR PCM : Lights up when Linear PCM signals
come in.
DIGITAL : Lights up when Dolby Digital signals
come in.
: Lights up when DTS Digital Surround
signals come in.
EN08-17.RX-6010&6012[US]_f 00.12.20, 2:22 PM 14