JVC CA-UXG210 - Manual (Page 11)

7
Listening to the FM Radio
To select FM
To tune in to a station
While FM is selected...
Station searching starts and the frequency indication starts
changing on the display.
When a station (frequency) with sufficient signal strength
is tuned in, the searching will stop.
To stop searching manually, press either button.
• When you press the button repeatedly, the frequency
changes step by step.
If the received FM station is hard to listen
Reception will improve though the stereo effect is lost.
The MONO indicator lights up.
To restore the stereo effect, press the button repeatedly to
select FM.
To preset the stations
You can preset 20 FM stations.
1
Tune in to the station you want to preset.
2
Activate the preset number entry mode.
• Finish the following process while the indication on
the display is flashing.
3 Select a preset number for the station.
4 Store the station.
To tune in to a preset station
1
Select FM.
2 Select the number of the preset station.
This system cannot receive AM broadcast.
FM(PRE) FM MONO
A-IN
FM/
AUDIO IN
(AUDIO IN)
TUNING/GROUP
1 sec.
FM/
AUDIO IN
FM(PRE) FM MONO
A-IN
(AUDIO IN)
To select a number, see “How
to select numbers” on page 6.
• You can also use
4 or x .
To select a number, see “How
to select numbers” on page 6.
• You can also use
4 or x .
The PROG. indicator lights up
on the display.
MHz
DISPLAY/
PROGRAM
1
4
7
0
2
5
8
3
6
9
10
DISPLAY/
PROGRAM
MHz
kHz
FM(PRE) FM MONO
A-IN
FM/
AUDIO IN
(AUDIO IN)
1
4
7
0
2
5
8
3
6
9
10
UX-G210[J].BOOK Page 7 Friday, November 20, 2009 10:23 AM