JAI CV-A11 - Manual (Page 22)

CV-A11
8. Specifications
Specifications
CV-A11
Scanning System Progressive 525 lines 30 frames/sec
Frame rate (Full frame) 29.96 Hz
Line frequency 15.734 kHz
CCD sensor Monochrome 1/3” IT CCD. Sony ICX424AL, (ICX084AL-6, old)
Sensing area 4.9 (h) x 3.7 (v) mm
Effective pixels 659 (h) x 494 (v)
Pixels in video output 648 (h) x 492 (v)
Cell size 7.4 (h) x 7.4 (v) µm
Resolution horizontal 480 TV lines
Sensitivity on sensor 0.05 Lux, Max gain, 50% video
S/N ratio > 56dB
Video output Composite VS signal, 1.0 Vpp, 75 Ω, DC Coupled
Gamma 0.45 or 1.0
Gain
Gain range Manual – Automatic
0 to + 15 dB
Accumulation Frame (Progressive scan)
Synchronization Int. x-tal, Ext HD/VD or random trigger
HD sync Input/output 4 Vpp, 75Ω
Trigger input 4 Vpp, 75Ω
WEN output (write enable) 4 Vpp, 75Ω
EEN output (exposure enable) 4 Vpp, 75Ω
Pixel clock output 4 Vpp,75Ω
Shutter 1/30, 1/50, 1/60, 1/125,1/250,1/500, 1/1000,
1/2000,1/4000, 1/10 000, 1/20 000, 1/40 000,
1/80 000,1/100 000 sec.
Pulse width control 1.5 H to 1000H
Start/stop 1/30 to 1/10 000 second
Long time exposure 1 frame to ∞
Programmable exposure 0.5H to 1023.5H
Frame delay readout Time from PWC trigger input to ext. VD input
Functions controlled by
RS-232C
Scanning format, Trigger mode, Shutter speed,
Trigger/WEN polarity, Accumulation, Shutter mode,
Programmable exposure, AGC level, White clip,
Setup, Manual gain, AGC/manual gain, Internal/
Potentiometer gain set, Gamma, Pixel clock,
Commands and internal adjustments.
Functions controlled by
Internal DIP switches VD input/output, HD input/output
HD, VD and 75Ω termination on/off
Operating temperature -5 to + 45
Humidity 20 – 80% non-condensing
Storage temp./humidity -25 to 60 /20% - 80%
Power 12V DC ± 10%, 1.8W Max.
Lens mount C-mount
Dimensions 29 x 44 x 66mm (HxWxD)
Weight 150g
9. Spectral Sensitivity
400 500 600 700 800 900
Wave Length (nm)
1.0
0.8
0.6
0.4
0.2
0.0
Relative Response
1000
Fig. 27. Spectral sensitivity.
- 21 -