JL Audio ZR650-CSi User Manual

Page 2

Advertising
background image

SB-GM-TRKCC/10W3v3_INSTR_SKU#011239

STEALTHBOX WALL

THREADED INSERT

VEHICLE SHEET METAL

FENDER WASHER

SOCKET CUP SET SCREW

LOCK WASHER

FLAT WASHER

HEX NUT

C o n G R a t u l a t I o n s
You have completed the installation for this model!

Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.

s t e P 6
Back out the socket cup set screws installed in steP 1, to
expose 1 1/4-inch.

From under the vehicle, place a supplied fender washer,
flat washer, lock washer and then hex nut onto the socket
cup set screw and secure. note: For added protection

it is recommended that you apply a bead of silicone

between the vehicle and the fender washer. after the

bolt assembly is tightly secured, it is also recommend-

ed that vehicle under-coating material is applied to

the exposed assembly

s t e P 5
With a drill and a 1/2-inch drill bit, drill through the
impression made in the wax squares. note: Before drilling,

make sure that you are not going to be drilling into

any gas lines, brake lines, transmission lines, electrical

wiring, transfer case (4x4 vehicles) or anything else

that might cause a reduction in your weekly pay.

always wear eye protection when drilling!

Remove the wax squares.

Run speaker wire from the amplifier’s location to the
Stealthbox

®

location and check for proper operation of

the woofer.

s t e P 4
Place the Stealthbox® into the mounting location and press
firmly onto the Stealthbox®.

Remove the Stealthbox® carefully, leaving the wax square
in place. The socket cup set screws will leave an impression
onto the wax square.

Page 2 • JL Audio, Inc 2007

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered

trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
Jla-sKu#011239 -09-06-2007 • Printed in USA • ©2007 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902

#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign

patents pending. For more detailed information please visit us online at www.jlaudio.com.

(954) 443-1100

w w w. j l a u d i o . c o m

1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A

I n C l u d e d H a R d W a R e

(2) 3/8-inch -16 x 2-1/2-inch Socket Cup Set Screw

(2) 3/8-inch -16 Hex Nut

(2) 3/8-inch Lock Washer

(2) 3-inch x 3-inch Wax Square

(2) 3/8-inch Flat Washer

(4) 3/8-inch Fender Washer

s P e C I F I C a t I o n s

Enclosure Type: Acoustic Suspension (sealed)

Driver Type: 10W3v3

Nominal Impedance: 4 ohms mono

Continuous Power Handling: 600 Watts

P o W e R R e C o M M e n d a t I o n

JL Audio recommends using a high quality amplifier such as the JL Audio 500/1v2.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2
when being used to power your Stealthbox

®

.

+12VDC

Ground Remote

Preamp Output Section

Infrasonic Filter

“Q”

Center Freq.

Boost (dB)

Amp LP Filter

Advanced

Bass

Control

Amplifier Input Section

Subwoofer Output

MONO OUTPUT ONLY

Left Output

Right Output

Left Ch.

Right Ch.

Filter Freq. (Hz)

Filter Freq. (Hz)

Infrasonic Freq. (Hz)

Remote Bass Port

Full Range | Amp Filter | Out Filter

Output Mode

Filter Slope

Mode

Mode | Slope

Input Voltage

Input Sens. Signal Sensing

12dB | 24dB

Filter Mode

LP | HP

Bass EQ

Off | On

Off | 12dB | 24dB

Low | High

Off | On

Off | On

40

45

55

65

80

100

200

15

18

22

30

45

55

60

40

45

55

65

80

100

200

0.5

0.7

1.1

1.6

2.7

4.3 20

25

30

40

60

75

80

0

+4

+10

+13

+15

500/1

v2

Monoblock Subwoofer Amplifier

The JL Audio 500/1v2 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.

M I d / H I G H F R e q u e n C Y d R I v e R F I t M e n t

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 6.5-inch / Front Doors

Fits JL Audio Models: TR650-CSi, TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi,

C5650, C5-650x & ZR650-CSi

Rear Speaker Size / Location: 5.25-inch / Rear Door

Fits JL Audio Models: TR525-CXi, VR525-CXi, VR525-CSi, C5-525x & C5-525

Advertising