JVC DR-MX10SEK User Manual
Page 25
Prepar
a
tions
EN
I
25
If auto setup was successful
The channel and correct time will be displayed on the
front display panel.
0
If VIDEO Plus+ timer programming is performed, the
guide programme number can be verified.
See AVIDEO Plus+ Timer ProgrammingB [ P52].
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT:
0
After auto setup, check the channels that were set. If
the same broadcast station was set to multiple
channels, delete the ones with poor reception. If the
same broadcast station was set to multiple channels,
the programme listing may not be displayed properly.
If auto setup was unsuccessful
The clock display on the front display panel will be
A- - : - -B. The channel may also not be displayed.
0
Check the antenna cable connection, switch off the
power, then perform auto setup all over again.
0
Set channels manually for broadcast stations with
poor reception.
See ASetting Receiving ChannelsB [ P36].
If you have any difficulty with the above procedures call the JVC Customer Service Hot Line on 0870 330
5000.
DR-MX10SE.book Page 25 Wednesday, December 14, 2005 3:37 PM