John Lewis JLDWW 906 - Manual (Page 8)

Multi tab button
Allows the use of combi detergent tablets (3
in 1 - 4 in 1 - 5 in 1, etc...). See ''Multi tab
function''.
Function buttons
In addition to the washing programme
selected, the following functions can also be
set using these buttons:
• setting the water softener level,
• cancelling a washing programme or a delay
start in progress,
• activation/deactivation of the rinse aid
dispenser (ONLY with Multi tab function
active).
Half load button
This option is useful and economical when
baskets are not fully loaded. It reduces the
consumption of water and energy.
Remember to load both baskets.
When using this option we recommend that
you reduce the dose of detergent that is
normally used for a complete load.
Press the half load button to activate the
option:
• the half load option is NOT available with
''45°-70° Auto'' programme; the half load
indicator light will not illuminate when the
half load button is pressed.
• the half load option is available with all the
other programmes; the half load indicator
light illuminates when the half load button
is pressed. This option has no impact on
some washing programmes. Refer to
''Washing programmes'' section.
Indicator lights
In addition to the programme indicator lights
that allow you to see which programme is
running or has been selected, other indicator
lights will help you in the use and maintenance
of your dishwasher.
Indicator lights
Multi tab Indicates the activation/deactivation of the Multi tab function (See Multi tab
function).
Half load Indicates the activation/deactivation of the half load option. (See Half load button).
Rinse aid 1) Illuminates when the rinse aid has run out.
Salt 1) Illuminates when the special salt has run out.
1) The salt and rinse aid indicator lights are never illuminated while a washing programme is running even if filling with
salt and/or rinse aid is necessary.
Setting mode
Press the On/Off button; if ALL programme
lights are illuminated the appliance is in setting
mode.
Always remember that when
performing operations such as:
• selecting a washing programme,
• setting the water softener level,
• activating/deactivating the rinse aid
dispenser,
the appliance MUST be in setting
mode.
8