JVC HR-XVC1UJ - Manual (Page 37)

37
4
Reading
Playback procedure
Press PLAY or OPEN/CLOSE.
The disc tray closes automati-
cally.
On the screen,
changes to
“Reading” and then playback will
commence.
• A menu screen may appear on
the TV screen, if the disc has
a menu feature. In this case,
press , , , or
ENTER to operate a menu
feature.
1
Press OPEN/CLOSE.
The disc tray will open.
2
Place a disc onto the tray.
Hold the disc, position it with the
printed label side up, align it with
the guides, and place it in its
proper position.
3
Press STOP to end playback.
• The DVD/VCR memorizes the stopped point, depending on
the disc. “ ” appears on the screen for approx. 4 seconds.
“ ” keep blinking in the display until the playback is stopped
completely. Press PLAY to resume playback (from the scene
point).
• If you press STOP again(“ ” appears on the screen) or unload
the disc, the DVD/VCR will clear the stopped point.
5
Then press OPEN/CLOSE.
The disc tray opens.
Remove the disc and press POWER.
The disc tray closes automatically and DVD/VCR turns off.
•
•
Note:
If a non-compatible disc is loaded, "Incorrect Disc", "Region Code Error" or "Parental Error" will appear on the TV
screen according to the type of loaded disc. In this case, check your disc again (See pages 35 and 46).
Some discs may take a minute or so to start playback.
•
•
•
•
A “Prohibition” symbol may appear at the upper left of the screen. This symbol means either the feature you
tried is not available on the disc, or the DVD/VCR can not access the feature at this time. This does not indicate
a problem with the DVD/VCR.
When you set a single-faced disc label downwards (ie. the wrong way up) and press PLAY or OPEN/CLOSE,
"Reading" will appear and remain on the screen for approx. 40 seconds and then it will change to "No Disc".
Some playback operations of DVDs may be intentionally fixed by software producers. Since this DVD/VCR plays
DVDs according to the disc contents the software producers designed, some playback features may not be
available. Also refer to the instructions supplied with the DVDs.
When playing DTS-encoded Audio CDs, excessive noise will be heard from the analog stereo outputs. To avoid
possible damage to the audio system, the consumer should take proper precautions when the analog stereo
outputs of the DVD/VCR are connected to an amplification system.
Turn ON the TV and set it to the video input mode.
Make sure TV/VCR/DVD switch has been slided to VCR/DVD.
Then press DVD to select the DVD mode. (The DVD indicator will light)
Preparation:
•
•
TV/VCR CH +
TV VCR DVD
POWER
DVD MENU MARKER RETURN OPEN/
CLOSE
DISPLAY A.TRK C.RESET ZERO RETURN
SUB TITLE ANGLE SEARCH
MODE
SP/EP
PLAY
MODE ZOOM TITLE REPEAT
A-B
TV
POWER
INPUT
TV VOL
0 TIMER TV/VCR
REW
PLAY
FF
REC
STOP
PAUSE
SKIP
/INDEX
SKIP
/INDEX
TV/VCR CH —
SET SET ENTER/
SELECT
SET UP
MENU CANCEL
OSD
A.MONITOR
SLOW SKIP
SEARCH
VCR/DVD/TV
2A30901AE(34-39) 5/13/02, 10:56 AM 37