Jensen ANHD20RTL12 - Manual

ANHD20RTL12 INSTALLATION guIde
Crank existing antenna to full elevation.
Remove 3/32” set screw from crank. Remove crank,
spring, directional handle, & 4 screws.
1
2
• Drill or Battery Driver with a #2 Philips bit
• Putty Knife
• 3/32” Allen wrench
• Electrical Tape
• Exterior Roof Sealant (Non-hardening type)
TooLs & suppLies
1
2
3
4
5
Remove sealant & screws from base,
remove antenna and clean surface
3
Apply sealant to all holes & attach exterior plate
using the included hardware
4
www.JensenRVDirect.com