JVC Micro Component System UX-GB9DAB - Manual (Page 7)

4
1 1 1 1 DAB antenna
For the better DAB reception
• See also “To improve DAB reception” on page 15.
2 2 2 2 AM/FM antenna
To assemble the AM loop antenna
To connect the AM loop antenna
• If the AM loop antenna wire is covered with vinyl, remove
the vinyl to expose the tip of the antenna by twisting the
vinyl.
For the better AM/FM reception
• Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75
Ω
wire with coaxial type
connector (IEC or DIN45325).
• Make sure the antenna conductors do not touch any other
terminals, connecting cords, or the power cord. Also, keep
the antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
DAB antenna (supplied)
Extend the wire so that you can
receive your desired ensembles.
Active antenna
(not supplied)
FM antenna (supplied)
Extend it so that you can
obtain the best reception.
AM loop antenna (supplied)
Turn it until the best reception is
obtained.
AM loop antenna (supplied)
Keep it connected.
Outdoor FM antenna
(not supplied)
Vinyl-covered wire (not supplied)
Extend it horizontally.
UX_GB9.book Page 4 Thursday, May 18, 2006 4:18 PM